Mini Kabibi Habibi

Current Path : C:/Program Files (x86)/Epson Software/Epson Printer Connection Checker/Language/HTML/US/
Upload File :
Current File : C:/Program Files (x86)/Epson Software/Epson Printer Connection Checker/Language/HTML/US/RESET.htm

��<font size="2" face="Meiryo UI"><u>Confirmation point during the wireless LAN connection:</u><br><br>



<table>

<tr valign="top">

<td><font size="2" face="Meiryo UI">[1]</font></td>

<td><b><font size="2" face="Meiryo UI">Because the network may have been unstable, restart the access point (wireless LAN router).</b><br>

Refer to the manual of the access point (wireless LAN router) for details.</font><br><br>

<table border="2" bordercolor="#FF7800" width=80% align="center" cellpadding="10">

<tr><td><font size="2" face="Meiryo UI">

<b>Note:</b><br>

Please be aware that restarting the access point (wireless LAN router) and the hub may affect the other users who have a network connection.</font></td></tr></table><br>

</td></tr>

<tr valign="top">

<td><font size="2" face="Meiryo UI">[2]</font></td>

<td><b><font size="2" face="Meiryo UI">Because there is the possibility that radio wave interference and obstacles may have caused access to be unstable, place the access point (wireless LAN router), computers, and printers close to each other.</b><br>

If there is an obstacle, try removing it or moving it in the same room.</font><br><br>

</td></tr>

<tr valign="top">

<td><font size="2" face="Meiryo UI">[3]</font></td>

<td><b><font size="2" face="Meiryo UI">Turn the printer off and back on again.</b><br>

In order to re-acquire the network information, wait about 10 seconds after you turn on the power of the access point (wireless LAN router), then turn the printer on.</font><br></td></tr>

</table>

<br><br>

<u>Confirmation point during Wired LAN connection:</u><br><br>

<table>

<tr valign="top">

<td><font size="2" face="Meiryo UI">[1]</font></td>

<td><b><font size="2" face="Meiryo UI">Restart the hub.</b><br>

Turn the hub off and back on again. Check the connection after about 1 minute.</font><br><br>

</td></tr>

<tr valign="top">

<td><font size="2" face="Meiryo UI">[2]</font></td>

<td><b><font size="2" face="Meiryo UI">Check the LAN cable.</b><br>

Make sure the LAN cable is firmly plugged into the connector of the hub or printer.</font><br><br>

</td></tr>

<tr valign="top">

<td><font size="2" face="Meiryo UI">[3]</font></td>

<td><b><font size="2" face="Meiryo UI">Check the light status of the hub.</b><br>

If the light is not flashing, insert the LAN cable in a different port, or replace the LAN cable. If there is still no improvement, replace the hub.</font><br>

</td></tr>

</table>

</font>